Camshaft gear drive kits increase valve timing accuracy by eliminating timing chain lash and loosely-fit stock chain drive
Reverses the rear cam's direction of rotation, providing additional operating clearance between cam lobes; as a result, higher cam lifts are possible with the gear drive kit
Kits include cams, inner gears, outer drive gears, inner and outer bearings, gasket and instructions
Material must be removed from the inner surface of the stock gear cover to install S&S gear drive cams
A hydraulic press and other professional-level tools are required to install these kits
Cam bearings and gaskets must be replaced when installing new cams
Kits require high-performance valve springs when installed in 99-04 models.
Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance.
Due to the inherent characteristics of gear drives, you may experience more valve train noise.
Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance.
Bolt-in cam for 103? and 106? Big Bore Twin Cam motors
Use with stock heads (up to 10.2 compression) and low restriction intake and exhaust
Great for lighter bikes with strong power from 3500-6000 rpm
Made in the U.S.A.
Exhaust Close Imperial: 26° Exhaust Open Imperial: 45° Intake Open Imperial: 20° Exhaust Close: 26° Exhaust Open: 45° Application: Exhaust| Intake Intake Close: 49° Intake Open: 20° Exhaust Lift: 0,575 inch Exhaust Lift Imperial: 0.575 inch Exhaust Duration: 251° Type: Gear Intake Duration Imperial: 249° Product Name: Cam Kit Exhaust Duration Imperial: 251° Intake Close Imperial: 49° Intake Lift Imperial: 0.575 inch Intake Duration: 249° Units: Set Grind: HP103 Intake Lift: 0,575 inch "
Camshaft gear drive kits increase valve timing accuracy by eliminating timing chain lash and loosely-fit stock chain drive
Reverses the rear cam's direction of rotation, providing additional operating clearance between cam lobes; as a result, higher cam lifts are possible with the gear drive kit
Kits include cams, inner gears, outer drive gears, inner and outer bearings, gasket and instructions
Material must be removed from the inner surface of the stock gear cover to install S&S gear drive cams
A hydraulic press and other professional-level tools are required to install these kits
Cam bearings and gaskets must be replaced when installing new cams
Kits require high-performance valve springs when installed in 99-04 models.
Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance.
Due to the inherent characteristics of gear drives, you may experience more valve train noise.
Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance.
Bolt-in cam for 103? and 106? Big Bore Twin Cam motors
Use with stock heads (up to 10.2 compression) and low restriction intake and exhaust
Great for lighter bikes with strong power from 3500-6000 rpm
Made in the U.S.A.
Exhaust Close Imperial: 26° Exhaust Open Imperial: 45° Intake Open Imperial: 20° Exhaust Close: 26° Exhaust Open: 45° Application: Exhaust| Intake Intake Close: 49° Intake Open: 20° Exhaust Lift: 0,575 inch Exhaust Lift Imperial: 0.575 inch Exhaust Duration: 251° Type: Gear Intake Duration Imperial: 249° Product Name: Cam Kit Exhaust Duration Imperial: 251° Intake Close Imperial: 49° Intake Lift Imperial: 0.575 inch Intake Duration: 249° Units: Set Grind: HP103 Intake Lift: 0,575 inch "